heat transfer coefficient of flue gases industrial boiler agents
HOT
Capacity:1-20t/h
Rated thermal efficiency: 100-104%
Fixed working pressure: ≤1.6MPa
Applicable fuel:natural gas etc.
HOT
Capacity:0.7-14MW
Rated thermal efficiency:96-98%
Fixed working pressure:≤1.25MPa
Applicable fuel:Natural gas, light oil, etc.
HOT
Capacity:0.7-2.8Mw
Rated thermal efficiency: 97.2-106%
Fixed working pressure:0.1MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:2.8-7.0Mw
Rated thermal efficiency:≥105.5%
Fixed working pressure:-0.02MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:99Kw
Rated thermal efficiency:97.2-104.4%
Fixed working pressure:1.0MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:0.5-4.0 t/h
Rated thermal efficiency:98%
Fixed working pressure:≤1.25MPa
Applicable fuel:electric energy
A heat exchanger with only one pass of the combustion products through it may not be nearly as efficient as one in which the hot gases make several passes; or, a boiler with large diameter flue tubes may not be as efficient as one with smaller tubes; so, design largely determines heat transfer efficiency and must be considered.Get Price
In the heat exchanger the flue gas is cooled and the waste gas heated. Configuration 2-1.4 is an incinerator fitted with a gas-to-gas heat exchanger and a heat recovery boiler. The preheater heats the incoming combustion air and the boiler extracts the heat available in the flue gas from exchanger outlet temperature.Get Price
Dec 27, 2021 · CO 2 (g) is a widely available and relatively inexpensive reagent, in particular contained in flue gases (CO 2-containing flue gas, including flue gases from thermal power plants), gases from bauxite ore sintering or calcination furnaces, boiler stack gas, or other industrial sources for carbonation.Get Price
Steam boiler solutions. Oil & Gas industry. Power plants. For instance, waste heat from the compressor can be recycled as hot water which could be used within certain manufacturing processes, or it could be redirected into the heating or hot water system of the building.Get Price
(B) If specified by the permit, carbon monoxide (CO), hydrocarbons (HC), and oxygen on a continuous basis at a common point in the boiler or industrial furnace downstream of the combustion zone and prior to release of stack gases to the atmosphere in accordance with operating requirements specified in paragraph (e)(2)(ii) of this section.Get Price
(B) If specified by the permit, carbon monoxide (CO), hydrocarbons (HC), and oxygen on a continuous basis at a common point in the boiler or industrial furnace downstream of the combustion zone and prior to release of stack gases to the atmosphere in accordance with operating requirements specified in paragraph (e)(2)(ii) of this section.Get Price
In the heat exchanger the flue gas is cooled and the waste gas heated. Configuration 2-1.4 is an incinerator fitted with a gas-to-gas heat exchanger and a heat recovery boiler. The preheater heats the incoming combustion air and the boiler extracts the heat available in the flue gas from exchanger outlet temperature.Get Price
Feel free to reach out if you want to collaborate with us, or simply have a chat.
